| light gun perfectly balanced and ideal for spraying Zn and / or aluminum molds and parts that need to be protected against corrosion. | |
| And’ It equipped with a powerful human DC motor or air motor to spray Cu, Inox, Mo, etc., connected to the transformer by means of a push-feeder. The wires are transported to the gun by a set of cables and flexible 3m in length. | |
| The diameter of the zinc wire can vary from 1,6 mm up to 2.5 mm. | |
| The gun is equipped with a "closed" system, or “open” depending on which is to be spray zinc or aluminum on pieces to wide or narrow surface. | |
| Gun Dimensions: length 200 mm, width 40 mm, height 190 mm | |
| Weight : 950 gr without cables | |
| compressed air: open 900 liters / minute, Closed 750 liters / minute | |
| The gun is connected to the generator by a set of 3 m length of insulated cables and hoses for compressed air, control cable and two flexible Teflon insulated electrically flowing strands of zinc and aluminum | |
| The generator is very compact and easily transportable. And’ three-phase protected by a stabilizer silicon, intrinsically cooled to prevent the formation of short circuits with inductive metal powders. Voltmeter and ammeter are placed on the front display of the generator . The rocker and the vernier can be adjusted according to operational needs. The current can vary from 20 a 130 At the touch of a potentiometer on the generator. On the rear of the generator is placed an additional filter for retaining any residues of water and oils that may be present in the central air system. | |
| By varying the selector and the vernier you can determine the optimal voltages for each type of metal. Compressed air can be varied by adjusting the pressure switch on the generator. | |
| Technical data: 3 phase 50-60Hz, 400 In | |
| compressed air: 0,9 m3/min a 5,5 bar | |
| Marcia: Voltage 18-32 Current volts 25-130 A | |
| Dimensions: 420 larg. mm-800 mm profonità -400 mm height |
